Q. When running DVR program, an error message comes up and the program stops
 
A.  Check if the driver is installed. The program runs normally when the driver of picture capture card is installed.

      And the diver and DVR software should be compatible each other.

      Check the model of DVR software : DVR program –> environment set-up –> general information

      Check capture driver card: control board –> system –> hardware –> system manager


      BDF0303 :

            “4Ch Video Capture Device”
            “4Ch Slave Capture Device”
 

      BDS0606 :

            “16Ch Video Capture Device”
            “16Ch Video Capture Device”
            “16Ch Slave Capture Device”
            “16Ch Slave Capture Device”
 

      BDS1212 :

           “16Ch Video Capture Device”
           “16Ch Video Capture Device”
           “16Ch Video Capture Device”
           “16Ch Video Capture Device”
           “16Ch Slave Capture Device”
           “16Ch Slave Capture Device”
           “16Ch Slave Capture Device”
           “16Ch Slave Capture Device”
 

     BDE2424 :

          “8Ch / 240 fps Capture Board”
 

     BDS2424 :
 
         “16Ch / 240 fps Capture Board”
 

    Overlay480 :

        “Overlay Board”